JMB-S
:
REV
A
DiBO
n.v.
105
5.6.2. Storage at freezing temperatures
Frozen water in the cleaner could damage parts of the cleaner.
Remove the water from the trailer at frost temperatures, turn the jockey wheel of trailer completely down and
open the drain valve in the front of the trailer.
Antifreeze filling function
Turn off the cleaner and remove the lance from the spray gun. Drain the remaining water from the tank
through opening the drain valve in front of the trailer. Add antifreeze (for mobile application, +- 15 litres) to the
water supply tank (loosen the cover of the water tank), to fill with antifreeze.
Put the electrical contact to position ‘ON’ (fuel engine not started)
!
Move the control stick downwards and simultaneously turn the key switch to position “START”.
The antifreeze filling function indicator is now active and appears on the display for 1.5 minutes (see 4.3)!
Start the fuel engine at idle speed! Spray till the antifreeze water flows out of the spray gun (this indicates that
the cleaner is filled with antifreeze) or wait till the antifreeze filling function time is ended.
Remember: loosen also the spray gun once, this to fill the bypass line with antifreeze.
5 seconds after extinguishing of the lamp, the cleaner will stop on “run dry water” (see section 11 - 4.2).
The cleaner is now filled with antifreeze, turn off the key contact and store the cleaner in a storage area.
Remark: pay attention to the water supply filter, these is not filled with antifreeze agent!
You can uncouple the supply water filter and put away the filter frost free.
You also can drain the water from the hose (eg.: by blowing with compressed air) or through the water filter
(by loosening the basket and draining the water from the hose).
Also pay attention to the option filling pump and associated filter: drain water / extract from the supply line.
Afterwards, turn on the filling pump and fill the supply line with antifreeze (by means of a tank at height).
Do not fill / blow off under pressure or compressed air at any circumstances!
Antifreeze is an additive which may absolutely not been drained/discharged without permission.
You have to collect the outlet antifreeze water in a reservoir. This is also the case when you use the
cleaner once more, the antifreeze water which has been left in the cleaner will then flow through.
Please do always take into account the matching security measures.
TIP: You can use the collected water with antifreeze several times!
At starting the cleaner again:
- Fill the tank with water and start the cleaner.
- Capture the antifreeze till water flows out of the spray gun (see below).
Option: filling kit antifreeze (see photo below - 1.230.100/101/102).
First loosen the basket from the water filter. Connect the filling set antifreeze to the low pressure coupling
and to the high pressure hose (closed circuit). Put the cleaner on idle speed and operate the spray gun.
Keep the spray gun pressed till there is filled with antifreeze to the water filter.
Turn the basket back on the filter and then push again on the spray gun.
Hold the spray gun until also the water filter (note the color of antifreeze in the water filter) is filled with anti-
freeze (+- 20 litres). Turn off the cleaner and disconnect the antifreeze filling set of the hoses.
The low pressure side is now also filled with antifreeze.
Low pressure coupling
Safety
valve
High
pressure
coupling
Summary of Contents for 1.780.260
Page 2: ...JMB S REV A DiBO n v 2...
Page 151: ...JMB S REV A DiBO n v 151 11 Technical data...
Page 158: ...JMB S REV A DiBO n v 158 12 Nozzle...
Page 160: ...JMB S REV A DiBO n v 160...
