JetBox-FloydSC User Manual rev 0.1
Page 32
4. To flash the Jetson Nano module, issue the following command as depicted below:
sudo ./flash.sh jetson-nano-emmc mmcblk0p1
Figure 17
Nano
BSP Installation Initiation
Module needs to be configured with user account first time. The user will be asked to enter few details to
configure the OS. Once this configuration is done the systems boots to ubuntu desktop.
Warning
:
Do not interrupt or interfere with the USB connectivity or the power supply to the carrier board
until the flashing procedure is complete
5. The flashing process will take 15-20 minutes to complete. The system will automatically Reboot when the
flashing process is complete.
Figure 18
Nano BSP Installation Completion
6. Shutdown the system and remove the recovery mode USB cable connection.
7. Remove the jumper on D from JP2 & mount it on H on JP2 as shown in
USB2.0 port 1 as a HOST
8. Switch on the power supply; now the system should boot to Linux Desktop
