HK 36 TC with Rotax 912 S3
Flight Manual
Normal
Procedures
Doc. No. 3.01.12-E
Rev. 1
06 Oct 2003
Page 4 - 6
Horizontal stabilizer installation
1.
Clean all bushes and bolts and apply a light coat of grease.
2.
Move trim knob to full NOSE DOWN position.
3.
Remove the Pitot tube.
4.
Position the horizontal stabilizer over the stabilizer mount; the elevator push-rod
must be connected by a second person.
WARNING
The elevator control system is not connected automatically!
5.
Slip the horizontal stabilizer onto both rearward bolts.
6.
Screw in the fastening bolt to the stop with an 8 mm hexagon key, applying
moderate hand torque (approximately 6 Nm (4.5 ft.lb)).
7.
Check the horizontal stabilizer for insecure attachment and inspect load trans-
mission of elevator control system.
8.
Install the Pitot tube.
9.
Apply water resistant adhesive tape to the gap between the horizontal stabilizer
and the vertical stabilizer.
Horizontal stabilizer removal
To remove the horizontal stabilizer reverse the above procedure.
