11
User's Manual |
GM341-GHF
Chapter 3
Chapter 3 - Installing Devices
Connecting the I/O Board
The system supports 32 digital inputs and outputs. The I/O board that came with the package
can be connected to the system to test the digital input and output function. Please observe the
following guidelines and follow the procedure to connect the I/O board.
1. Make sure the system and all other peripheral devices connected to it have been powered off.
2. Disconnect all power cords and cables.
3. Connect one end of the USB cable (type-A connector) to the system and the other end of the
USB cable (type-B connector) to the I/O board.
4.
Connect the I/O board to the system's intrusion detection connector (labeled door 1~6) using
the red cable.
5.
Connect the I/O board to the system's DIO port (labeled
DO: 17~32) using the blue cable.
6.
Connect the I/O board to the system's DIO port (labeled
DO: 1~16) using the green cable.
7.
Connect the I/O board to the system's DIO port (labeled
DI: 17~32) using the yellow cable.
8.
Connect the I/O board to the system's DIO port (labeled
DI: 1~16) using the orange cable.
Red: Door 1~6
Blue DO: 17~32
Green DO: 1~16
Yellow DI: 17~32
Orange DI: 1~16
Powering on the System and Connecting the Display
To power on the system, simply connect the 4-pin power cable to the system and the system will
be automatically powered on. If you want to use a power or a reset switch (tact button), they are
located on the system board as shown in the following picture.
To connect the display, use a DisplayPort cable to connect one of the DP ports to a display device.
Power LED
HDD LED
Power Button
Reset Button
4-pin DC-in
DP 0
DP 1
DP 2
DP 3
Note:
The tact buttons on the I/O board can be used to invoke a door intrusion event or set
the high/low level of a digital I/O port. You can also use the demonstration application
to alter a digital I/O port’s level. For more information, please refer to the software ap-
plication guide.