DFE SteadyWeb, Instruction Manual

Page: 5 / 80

SECTION TWO INSTALLATION OF STANDARD UNIT
2.0 Dimensions 9
2.1 Installing the Enclosure 10
2.2 Electrical Connections 11
2.3 Electrical Connections for Options 12
SECTION THREE INSTALLATION OF H6 AND CC
CONFIGURATIONS
3.0 H6 Configuration 13
Dimensions 14
3.1 CC Configuration 15
Dimensions 15
Electrical Connections 16
SECTION FOUR CALIBRATING THE TENSION METER
4.0 Mechanical Zero 18
4.1 Calibration 18
SECTION FIVE SET-UP AND ADJUSTMENTS OF
STANDARD UNIT
5.0 Tension Zones 20
5.1 The Control Board 21
5.2 The Power Board 22
5.3 Power Voltage Selection 23
5.4 Control Voltage Selection 23
5.5 4-20mA or 0-20mA Output 24
5.6 Emergency Stop 25
5.7 High Voltage Output Module (12V only) 26
5.8 Meter Correlation 27
5.9 Meter Damping 27
5.10 Output Direction 27
5.11 Output Meter 28
5.12 Pneumatic Output Module (12P only) 28
5.13 Ratio Up/Down 29
5.14 Remote Tension Amplifier Installed? 30
5.15 Remote Tension On/Off 30
5.16 Remote Tension Set 30
5.17 Sample and Hold 31
5.18 Soft Start 31
5.19 Speed Follow 33
5.20 Tachometer Card Installed? 34
5.21 TLS Card Installed? 34
5.22 Transducer Voltage Selection 34
SECTION SIX SET-UP AND ADJUSTMENTS OF OPTIONS
6.0 220 Volt Power Input 36
6.1 24 Volt Output 36
6.2 45 Volt Output 36
6.3 DC Tachometer Card 36
6.4 Digital Meter 38
6.5 Dual Calibration 40
6.6 Dual Transducer Input 40
6.7 Extended Range 40
6.8 Pulse Tachometer Card 40
6.9 Remote Tension Amplifier 42
6.10 Taper Adjustment of Front Panel 43