8
In order to properly fit
on the
, slot on
as shown and fasten in
place using the two enclosed
.
In order to
the drive
, remove
, pull off
and
pull out the plug from plug-in station no. 5 (see page 18).
cap (1)
DUOMAT 7 (3)
cap (1)
screws (2)
shut down
in an emergency
screws (2)
cap (1)
b)
Electrical connection
Operating Instructions
mains connection lead
driven over
Mechanical loads should also be avoided.
mains connection lead
strain relief
kink protection
mains connection lead from trailing on the floor
moved
slave drives and controls
blind plugs
external battery
holder
socket designated for the battery
backup system
cap
screws (2)
In the
to be issued by you, point out to the operator that if leads, in
particular the
, are
they could sustain damage.
When routing the cables make sure that they
cannot get entangled or trapped,
are not subjected to mechanical loads (i.e. do not pull, apply pressure or bend),
cannot get damaged in any other way.
Make sure that the cables, in particular the
, are fastened to the bed
with adequate
and
and that suitable constructional measures
prevent the
when the bed is being
.
First connect the
, as shown (see page 18). Make sure that any
sockets not being used are sealed off with
(protection against spray water
IP44).
If you intend connecting an
(e.g. for emergency lowering), engage the
battery in the
provided (see page 18, pos. 5)
If necessary, remove the cap and blind plug from the
and connect the lead for the battery backup system there.
Then fasten the
over the plug using the enclosed
.
"
"
"
3
1
2
DUOMAT 7 CARE L/HOSP L
