65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel: +359 56 820027, Fax: +359 56 836700
E-mail: [email protected] ,Web: www.devabroadcast.com
- 61 -
PI CAMPAIGN AND LOGGER MODE
Differences between PI campaign and Logger Mode.
Which type of campaign should I choose?
Designed for signal surveillance on the field where the listeners are, all that is needed is a
vehicle and Radio Explorer II. There are two campaign modes:
1.
Logger mode
– Trough this section of the WEB Interface, up to fifty radio frequencies could
be chosen and monitored, by applying the needed settings. When the desired adjustments
are made, Radio Explorer II will monitor all of the selected frequencies at regular intervals.
All of the collected information is accessible through the built-in FTP Server;
2.
RDS PI / RBDS CALL
campaign – Radio Explorer II can monitor up to ten stations at
regular intervals. When used in this mode, Radio Explorer II will automatically detect the
used frequency. While the campaign is running, the chosen stations will be monitored;
Radio Explorer II will automatically switch over between the variable frequencies during
movement - just as the car radio of your listeners. It is necessary that the campaign
frequencies/channels and supplemental Radio Explorer II settings be pre configured before
starting a campaign. No additional adjustments or settings will be required, except for the
occasion when the campaign is to be stopped.
RDS PI / RBDS CALL campaign - PI campaign
•
The PI campaign is suitable solution when monitoring of an entire network is made. In
order for a PI/CALL campaign to be made, the channels you would like to monitor must
have RDS PI / RBDS CALL signs.
•
This campaign type is very convenient when it is not preliminary known which transmitters
will be in the range of the survey, but the PI or CALL signs of the stations are available.
•
When used to monitor an entire network, the PI campaign allows you to set-up the PI/CALL
signs once and use them in campaigns for unlimited time without the need of changing them
depending on the region of survey.
•
Allows you to identify the zones of switch over from one transmitter to another.
Logger mode
• The Logger mode is suitable solution when monitoring of a preliminary identified frequencies
should be made.
•
This campaign type is very convenient when a survey for the coverage of one transmitter in
a particular city or region should be made.
•
Appropriate when several transmitters in a relatively small region should be monitored and
all channels of interest are broadcasted at the same time/simultaneously.
