65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel: +359 56 820027, Fax: +359 56 836700
E-mail: [email protected] ,Web: www.devabroadcast.com
- 28 -
Parameter control state
The parameter control state allows specific parameters to be set before starting the bandscan.
OK
– show/hide Parameter control
Left / Right Buttons
– cycle through the available parameters.
Up / Down Buttons
– change the value of the selected parameter.
The name and value of the selected parameter appear briefly on the data plot.
NOTE:
Parameter control state will automatically disappear from the screen if no button is
pressed for 2 seconds.
Bandscan page parameters
Bandscan
: Start / Stop – Used for starting/stopping of the bandscan process. Information about
the progress will be displayed on the right bottom corner of the data plot. Upon completion, the
Bandscan parameter value will be automatically set to “Stop”.
Bandscan in progress
Running bandscan can be stopped manually by setting the Bandscan parameter value to “Stop”.
Start Frequency
: – set the start frequency of the bandscan.
End Frequency
: – set the end frequency of the bandscan.
Step
: 10, 20, 50 or 100 kHz – set the step increments of the band. Small steps lead to higher
resolution but slower bandscan;
RF Input
: Antenna 1/Antenna 2 – select the antenna input to be used during bandscan;
Pressing
SB4
in Bandscan page will lead back to the previous page.
NOTE:
Leaving the page will not stop the bandscan process. The process will continue until it
is finished or the Bandscan parameter value is set to “Stop”.