Contact Us
|
|
+1 (332) 228-1098
10
COUNTING OPERATION
IMPORTANT
: Before turning on the Aura DT100, please make sure that no
coins are present in the Coin Hopper. This will cause an
“ER”
Error when
the Self-test is performed. To Clear the
“ER”
Error, press the
“START/STOP”
button, then empty any coins present in the coin trays.
Turn on the Power Switch located on the rear of the machine. The unit will
conduct a self-check to confirm the proper operation of all its modules before
starting the count.
The Main Display will show “0” when the test has successfully completed. If any
error is reported, refer to the maintenance and troubleshooting section of the
manual.
I. COUNTING:
The machine always operates in batching mode. To enable simple counting, all
batch quantities need to be set to zero.
To set batch quantities to zero, press and hold the “-” button for approximately
three to five seconds until you hear a beep.
1.
Before loading the hopper, please make sure there are no uncounted
coins remaining from the previous count.
2. To count coins, place them into the hopper and press the
“START/
STOP''
button. The machine will automatically sort all coins into the
appropriate coin trays.
3.
The machine will automatically stop when all the coins in the hopper
are counted, or if the batch quantity for any coin denomination is
reached.
4. To stop the machine at any time during the count, press the
“START/
STOP”
button. Resume the count by pressing the same button.
5.
To reset the coin count before starting a new batch, press the
“C”
button.
Summary of Contents for DT100
Page 1: ......
