![background image](http://html1.mh-extra.com/html/desa/vul18nr/vul18nr_owners-operation-and-installation-manual_2485676024.webp)
www.desatech.com
119426-01F
24
O
FF
P
ILO
T
LO
IH
ON
OFF
REMOTE
O
N
OPERATING HEATER
Continued
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 6 under
Light-
ing Instructions
, pages 22 and 23.
2. Depress control knob and light pilot
with match.
3. Keep control knob pressed in for 30
seconds after lighting pilot. After 30
seconds, release control knob. Now
follow steps 9 through 11,
Lighting In-
structions
, page 23.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note:
All remote control accessories must
be purchased separately (see Accessories,
page 41). Follow instructions included with
the remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See
Lighting
Instructions
on page 22.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON
position. Adjust flame adjustment knob
anywhere between HI and LO. Slide the
selector switch to the REMOTE position
(see Figure 35).
Note:
The burner may light if hand-held
remote was on when selector switch
was last turned off. You can now turn
the burner on and off with the hand-held
remote control unit.
IMPORTANT:
Do not leave the selector
switch in the REMOTE or ON position
when the pilot is not lit. This will drain
the battery.
ON/OFF SERIES (MODEL HRC100)
Hold the control button on the hand-held
remote until burner turns on. Hold the
control button again until burner turns off
(see Figure 36).
TO LOCK press both buttons on hand-held
remote control until light stops flashing.
Hand-held remote control is now locked. If
the fire is on it will be turned off automati-
cally. In the locked state, the light will not
light up when any button is pressed. TO
UNLOCK press both buttons together on
hand-held remote control until the light
stops flashing. The hand-held remote is
now unlocked.
Figure 36 - On/Off Hand-Held Remote
Control Unit
Figure 37 - Thermostat Hand-Held
Remote Control Unit
Figure 35 - Setting the Selector switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
Selector Toggle Switch (Optional
Hand-Held Remote Control)
Control Knob in
On Position
Flame Adjustment
Knob
Control
Button
Indicator
Light
LOCK
MANU
AUTO
C/ºF
TEMP
POWER
ROOM
TEMP
SET
TEMP
AUTO
Turns
Hand-Held
Remote On
or Off and
Allows You
to Choose
the Manual
Setting
Selects
AUTO
Mode
°C/°F Mode
Button
Locks
System to
Prevent
Accidental
Ignition
Turns
Burners
On or
Off
Increases or
Decreases
Room
Temperature in
AUTO Mode
Digital Display Shows
Temperature and Settings
THERMOSTAT SERIES (MODEL
HRC200)
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 37). To select
Fahrenheit/Centigrade mode display, care-
fully press the ˚C/˚F mode button with the
end of a paper clip or similar blunt object.