www.desatech.com
121486-01F
20
OPERATION
Continued
FAHRENHEIT/CELSIUS INDICATOR
You can set your hand-held remote control to
display the temperature in either Fahrenheit or
Celsius. With remote control off, press THER-
MOSTAT button and MODE button at the same
time. This will toggle the display from °F to °C.
Figure 31 - Remote Control Display
Fahrenheit to Celsius
OPERATING REMOTE CONTROL
WARNING: Fireplace can
turn on suddenly. Keep away
from burner.
After lighting pilot, let pilot flame burn for about
one minute. Slide remote selector switch to
REMOTE position. You can now turn the
burner on and off with the remote.
IMPORTANT:
Do not leave selector switch in
the REMOTE or ON position when pilot is not
lit. This will drain batteries.
When any button is pushed on remote control,
the LCD display will glow blue. The blue glow
will go off after several seconds if no action is
being taken with remote.
ON/OFF
Push ON/OFF button and burners will come
on in high position (see Figure 32). A beep
from the receiver confirms the command.
Push ON/OFF button again and burners will
turn off. A beep from the receiver confirms
the command.
Figure 32 - Hand-Held Remote Control
ON/OFF
MODE
UP/ DOWN
Arrows
THERMOSTAT
LCD
Display
ON
ON
MAX
Figure 33 - Remote Control Display of
Flame Height Minimum and Maximum
MINIMUM
MAXIMUM
FLAME HEIGHT
This function allows you to control the height
of the flames through 5 levels. Select manual
flame height function by pressing MODE button
until a flame is shown in lower left corner of
display. Use the UP/DOWN arrow button to set
desired flame height (see Figure 32). A beep
from the receiver confirms the command.
ROOM THERMOSTAT
The remote control can operate as a room
thermostat. The thermostat can be set to a
desired temperature to control the comfort
level in the room.
To activate, press THERMOSTAT button on
remote control (see Figure 32). The word
ON will appear to the right of temperature
bulb graphic on display (see Figure 34, page
21). Use UP/DOWN arrow button to set de-
sired room temperature. Control system will
cycle fireplace on or off to maintain selected
temperature.
