www.desatech.com
119162-01H
18
INSTALLATION
Continued
2
3
4
5
6
Figure 24 - Installing Log #2
Figure 25 - Installing Logs #3 and #4
Figure 26 - Installing Logs #5 and #6
1
Figure 23 - Installing Log #1
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With heater set to Hi, check to
see if flames contact any log. If
so, reposition logs according to
log installation instructions in
this manual. Flames contacting
logs will create soot.
VGC and EC Model Series
It.is.very.important.to.install.these.logs.exactly.
as.instructed..Do.not.modify.logs..Only.use.
logs.supplied.with.heater.
1.. Place.rear.log.(#1).on.base.assembly.as.
shown in Figure 23. Log will fit over right end
of.burner.and.rest.in.middle.of.U-burner.
2.. Place.middle.log.(#2).in.front.of.U-burner.
and.against.the.edges.of.plate.as.shown.
in.Figure.2.
3.. Place. front. left. log. (#3). onto. pan. burner.
between. log. #2. and. grate..
Back of log
#3 should fit against front of log #2.
.
Place.front.right.log.(#).onto.pan.burner.
between.log.#2.and.grate..Logs.#3.and.#.
have notched ends to fit over end of pan
burner.as.shown.in.Figure.25..
Back of log
#4 should fit against front of log #2.
.. Place.right.crossover.log.(#)5.as.shown.
in.Figure.26..Match.round.peg.on.top.of.
rear.log.(#1).with.round.hole.on.bottom.of.
right.crossover.log.(#5).and.square.peg.
on.top.of.middle.log.(#2).with.square.hole.
on.bottom.of.crossover.log.(#5).