![background image](http://html.mh-extra.com/html/desa/ec18nr-pr/ec18nr-pr_owners-manual_2485858017.webp)
www.desatech.com
119162-01H
17
INSTALLATION
Continued
Figure 20 - Installing Remote Receiver
Bracket
6.. Install.receiver.bracket.to.base.with.phil-
lips. screws. provided. in. hardware. kit. as.
shown.in.Figure.20.
7. If installed, disconnect AUTO/OFF/ON
switch. wire. from. control. valve. at. TPTH.
and.TH.locations.(see.Figure.21).
8.. Install. remote. receiver. into. receiver.
bracket.using.pads.and.push.button.clips.
provided.with.receiver.(see.Figure.20).
9.. Connect.wires.from.hardware.pack.(with.
remote.receiver.bracket).to.control.valve.
at.the.TPTH.and.TH.locations.as.shown.
in.Figure.21..Connect.other.ends.of.these.
wires.to.remote.receiver.wires.
Note: Make sure excess wire does not
interfere with burner or pilot.
10..
If heater was removed from fireplace be
-
fore installation of remote accessory, see
Installing Heater Base Assembly
.on.page.
12 to reinstall heater into fireplace. Test gas
connection. for. leaks. (see.
Checking Gas
Connections
, page 15).
Figure 21 - Disconnecting Switch from
Control Valve
Figure 22 - Installing Battery in Hand-Held
Remote Control Unit
9-Volt.Battery
Battery.
Housing
Battery.Cover
Terminal.
Wires
Remote.
Control.
Unit
Remote.
Receiver.
Bracket
Electronic.Ignitor.
(On.Base.Assembly)
Push.
Button.
Clips
Pads
9-Volt.
Battery
Battery.
Clip
Terminal.Wires
Switch
Control.
Valve
11..If.logs.were.removed.from.heater.for.install.
remote accessory, replace logs (see
In-
stalling Logs
,
Embers and Lava Rock
).
Installing Batteries for Remote Receiver
and Hand Held Remote Control
Two.9-volt.alkaline.batteries.(not.included).are.
required.to.operate.this.heater.with.the.wireless.
hand-held.remote.control.set..One.battery.must.
be.installed.in.the.receiver.and.one.in.the.hand-
held.remote.control.unit.
Note: Only use alkaline batteries.
Installing 9-Volt Battery in Receiver
1.. Locate.back.of.receiver.behind.receiver.
bracket.mounted.on.base.assembly.
2... Locate. the. battery. clip. mounted. on. the.
back.of.the.receiver.(see.Figure.22)..
3.. Slide.a.9-volt.battery.through.the.clip.
.. Attach.the.terminal.wires.to.the.battery.
Installing 9-Volt Battery (Not Included) in Hand-
Held Remote Control Unit
1.. Remove. battery. cover. on. back. of. re-
mote.control.unit.
2.. Attach.terminal.wires.to.the.battery..Place.
battery.into.the.battery.housing.
3... Replace. battery. cover. onto. remote.
control.unit..
INSTALLING LOGS, EMBERS AND
LAVA ROCK
WARNING: Failure to posi
-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.