Denso BHT-1260BWB-CE, User Manual

Page: 169 / 251

157
Barcode Handy Terminal/2D code Handy Terminal
Hand Held Terminal
Barcode Handy Terminal
4.7.2 General
Tap the “General” tab in the WWAN manager.
The screen on the right is displayed.
Tap the
“Power ON” button to turn ON the WWAN module.
Tap the
“Power OFF” button to turn OFF the WWAN module.
The following information is displayed when the WWAN module is ON.
Section Item Value Meaning
SIM Status Removed
The SIM card is not inserted or the
WWA module is not turned ON.
WWA module is not turned ON
Ready The SIM card is ready to use.
Waiting for PIN1 Waiting for PIN1 to be entered.
Waiting for PUK1 Waiting for PUK1 to be entered.
Phone Number - Phone Number
Network Carrier No Service
Out of service area, or the WWAN
module is not turned ON.
(Carrier name)
Status GPRS available GPRS is available
GPRS in use GPRS is in use
EGPRS available EGPRS is available
EGPRS in use EGPRS is in use
3G available 3G is available
3G in use 3G is in use
HSDPA available HSDPA is available
HSDPA in use HSDPA is in use
HSDPA/HSUPA available HSDPA/HSUPA is available
HSDPA/HSUPA in use HSDPA/HSUPA is in use
Signal Strength 0 - 100 Signal Strength
Data
Connection
Connection (Connection name)
The connection name set in the data
connection tab menu.
APN (Access point name)
The access point name set in the
data connection tab menu.
Status Disconnected Data connection is disconnected.
Connected Data connection is connected.
-
Note
-
If the above information is not shown, tap the “Power OFF” button then tap the “Power
ON
” button to restart the WWAN module.
If the internet connection is disconnected, tap the
“Disconnect” button then tap the
“Connect” button to reconnect to the internet.
The “Connect” and “Disconnect” button will be enabled when data connection settings are configured.
Tap the
“Connect” button to start data connection, and tap the “Disconnect” button to stop data connection.
Refer to 4.7.3 DataConnection
– [1] Data connection setup for details.