9
ENGLISH
Basic version
Advanced version
Information
Simple version
Set up speakers (Audyssey® Auto Setup)
STEP 4
Calculation
STEP 5
Check
11
On the
STEP 3
screen, use
ui
to select “Next
1
Calculation”, and
then press
ENTER
.
Measuring results are analyzed, and the
frequency response of each speaker in the
listening room is determined.
[4/6]
AUTO SETUP
AUDYSSEY AUTO SETUP
MultEQ
STEP4 Calculation
Now calculating...
Please wait.
25%
• Analysis takes several minutes to complete. The
time required for this analysis depends on the
number of speakers connected.
The more connected speakers there are, the
longer it takes to perform analysis.
Remote control operation
buttons
Move the cursor
(Up/Down/Left/Right)
Confirm the setting
Return to previous menu
NOTE
• If the result differs from the actual connection
status, or if “Caution!” is displayed, see “Error
messages” (
v
page 10). Then carry out Audyssey
Auto Setup again.
• If the result still differs from the actual connection
status after remeasurement or the error message
still appears, it is possible that the speakers
are not connected properly. Turn this unit off,
check the speaker connections and repeat the
measurement process from the beginning.
• If you change a speaker position or orientation,
perform Audyssey Auto Setup again to obtain
optimal equalizer correction.
12
Use
ui
to select the item you want
to check, and then press
ENTER
.
[5/6]
STEP5 Check
Check processing res-
ults. To proceed,press
“Next”
Select item to check
Spkr Config Check
Distance Check
Ch. Level Check
Crossover Check
Next Store
AUTO SETUP
AUDYSSEY AUTO SETUP
MultEQ
ENTER
Enter
RETURN
Cancel
• Subwoofers may measure a greater reported
distance than the actual distance due to added
electrical delay common in subwoofers.
• If you want to check another item, press
RETURN
.
13
Use
ui
to select “Next
1
Store”
and then press
ENTER
.
STEP 6
Store
14
Select “Store” and then press
ENTER
.
Save the measuring results.
[6/6]
AUTO SETUP
AUDYSSEY AUTO SETUP
MultEQ
STEP6 Store
Now storing...
Please wait.
25%
[6/6]
STEP6 Store
Press “Store” to store
calculation results.
Apply and store measurement result
Store
AUTO SETUP
AUDYSSEY AUTO SETUP
MultEQ
ENTER
Enter
RETURN
Cancel
• Saving the results requires about 10 seconds.
• If the measuring results are not to be saved,
press
RETURN
. A message “Cancel Auto
Setup?” will be displayed. Press
o
then select
“Yes”. All the measured Audyssey Auto Setup
data will be erased.
NOTE
During saving of measuring results, be sure not to
turn off the power.
Finish
NOTE
After performing Audyssey Auto Setup, do not
change the speaker connections or subwoofer
volume. In event of a change, perform Audyssey
Auto Setup again.
15
Unplug the setup microphone from
the unit’s SETUP MIC jack.
16
Set Dynamic Volume™.
[6/6]
Finish
Storing complete.
Auto Setup is now
finished. Please unplug
microphone.
Turn on Dynamic Volume?
AUTO SETUP
AUDYSSEY AUTO SETUP
MultEQ
ENTER
Exit
Turn Dynamic Volume on and exit Auto Setup
Yes
No
• For details of Dynamic Volume settings, see
page 53.
n
When turning Dynamic Volume on
• Use
o
to select “Yes”, and then press
ENTER
.
The unit automatically enters “Evening” mode.
n
When turning Dynamic Volume off
• Use
p
to select “No”, and then press
ENTER
.
