DeLUX MOISTURE Link G2 DP, Operation Manual

Page: 18 / 322

DRYER CONTROLS
4

A) PRIMARY SAFETY CIRCUIT: When illuminated, this indicates that the primary
safety circuit is proven.

B) BURNER SAFETY CIRCUIT: When illuminated, this indicates that the burner safety
circuit is proven.

C) DRYER FILLL: When illuminated, this indicates that the dryer fill system is running
and the high/low fill switch is in the LOW position. If the LOAD OPERATION switch is
in the ON position and the light is not illuminated the switch is in the HIGH (full)
position.

D) DRYER DISCHARGE: When illuminated, this indicates that the UNLOAD
OPERATION is on and the dryer is discharging grain.

E) AIR PROVEN: When illuminated, the fan(s) have proven airflow.

F) BURNER READY: When illuminated, the 30 second purge cycle has completed and
the burner(s) are ready to be lit.

G) BURNERS PROVEN: When illuminated, burner(s) have proven flame.

H) PLENUN TEMP: The top temperature (ORANGE) is the current temperature inside
the plenum. The bottom boxed number (GREEN) is the current set point for the
plenum temperature. Adjust the plenum temperature set point by pressing it and
entering a new value.

I) CURRENT DATE/TIME: This is the current system date and time. Since the dryer
logs and graphs are based on this date and time, it is important that they are
adjusted before the beginning of each drying season.

J) MODE: This indicates the drying mode the dryer is currently in. To change the
mode press the field on the screen and use the UP/DOWN arrows to toggle between
modes.

K) MOISTURE OUT: The (ORANGE) value on the left indicates the temperature of the
grain exiting the dryer. The (ORANGE) value on the right indicates the instantaneous
moisture value of the grain exiting the dryer. The bottom boxed number (GREEN) is
the current set point for moisture exiting the dryer. Adjust the moisture set point by
pressing the field on screen and using the UP/DOWN arrows to toggle between set
points. Set points can only be set in 0.5% increments.
16