6
Operating manual for LT series cooling water heat exchanger
5.
Transport
The heat exchanger may only be transported upright and with a completely empties
cooling fluid vat. The warning signs on the packaging should imperatively be observed.
Only use adequate transportation aids such as lifting equipment or forklifts during
transportation.
The delivery of the device is made with filled cooling fluid. When employing a
transporter, they should be informed of this. The type and quantity of cooling fluid are
provided in section 1.
The respectively applicable safety regulations are to be followed when transporting in
different countries or by boat or airplane. The safety data sheet for the used cooling
fluid may be obtained on demand from the manufacturer.
Before unpacking the heat exchanger, check the packaging or the device for any visible
transportation damage. In case of transportation damage, notify the transporter and the
manufacturer immediately.
If lifting brackets are available, always use all available lifting brackets during
transportation as non-compliance may cause damages to the housing and components.
When using lifting brackets, a lifting crossbeam should imperatively be used.
NO
STEP
