4
Operating manual for LT series cooling water heat exchanger
Along with the general safety information listed in the following, you will find further
safety information in this operating manual under the main points as well as in the
section "In case of emergency". The directives and standards not named here also
retain their validity.
This operating manual contains basic information to be followed during setup, operation
and maintenance. Therefore, the operating manual is to be read by the assembler and
operator before the assembly and commissioning and should be constantly available on
the site of operation of the machine/installation.
Persons who are not familiar with this operating manual as well as children and
adolescents below age 16 may not use the device and should be kept away from the
connected device.
The working area is to be locked off in accordance with the task and should correspond
to the local directives on work protection.
Use personal safety equipment such as safety shoes, rubber gloves, protective goggles
and a helmet.
Ensure that all evacuation routes from the work area are unobstructed.
In order to prevent asphyxiation and poisoning, a sufficient oxygen supply to the
workplace is to be ensured and the absence of poisonous gases should be verified.
If work is to be performed with welding equipment or electrical tools, ensure that there
is no danger of explosion.
All safety and protective installations are to be mounted and started up immediately
after the end of works.
The operator is responsible for third parties in the working area.
We draw your attention to the fact that according to product liability regulations, we are
not responsible for damages caused by our device in the case where information and
directives from this operating manual are not respected. The same regulations apply for
accessories.
