Delta SVG300A43A-11, Quick Star

Page: 77 / 127

Product Installation
2-9
(Note 1 & 2).
Note 1: Aperture of fixing holes a1 ~ a4: Ø 18mm; aperture of fixing holes a5, a6: Ø 14mm.
You can use (Ø18) M16 or (Ø14) M12 studs for fixation.
Note 2: Before using the base-fixing holes a3, a4 located in the back, remove the 38 S1-S19,
M5 screws of the side boards as shown in Figure 2-5 to fix a3 and a4.Afterward,
please screw the side boards back into their original position. Screw torque: 24 to
26 kg-cm [20.83 to 22.57lb.in] (2.35 to 2.55N.m).(Note 4)
Note 3: If the sideboards get in the way, please lock the fixing holes in the back onto the
L-shaped iron plates, as shown in c3 to c4 of Figure 2-7.
Note 4: To remove the side boards, as shown in Figure 2-5, loosen the S1 to S3 screws first,
and then remove the S4-S19 screws. Pull the board open approximately 45° to
remove the board to facilitate fixing the base-fixing holes a3, a4 located in the back.
Afterward, please screw the side boards back into their original position.
4. 5 other installation methods are also provided. Please select a suitable installation method.
All other installation methods are not approved by Delta, and Delta will not be responsible for
damages dealt to the cabinet due to inappropriate installation methods.
5. If a customer needs to elevate the cabinet because of the venue, please refer to Figure 2-8
to elevate the four sides to ensure the safety of the cabinet.
In situations where the installation environment may cause the whole system to sway,
please use installation method 4 as the fixing method.
Installation 1: Refer to Figure 2-7, fix the base-fixing holes a1 and a2 at the front of the
cabinet, as well as the top fixing holes a5 and a6 at the back.
Installation 2: Refer to Figure 2-7, fix the L-shaped iron plate c1 to c4.
Installation 3: Refer to Figures 2-6 and 2-7, fix the L-shaped iron plate c1, c2 and top fixing
holes a5, a6 at the back.
Installation 4: Refer to Figures 2-6 and 2-7, fix the base-fixing holes a1, a2 at the front of the
cabinet, base-fixing holes a3, a4 at the back, and the top base-fixing holes a5, a6
at the back.
Installation 5: Refer to Figures 2-6 and 2-7, fix the L-shaped iron plate c1 to c4 and top fixing
holes a5, a6 at the back.