Delta SVG300A43A-11, Quick Star

Page: 98 / 127

Specifications
3-7
3-3 Control terminal description
Figure 3-1 Control terminal location
Position Suitable wire size Torque
A 24~10AWG 14.3Kg-cm(12.41 lb-in) (1.4N.m)
B 8Kg-cm(6.94 lb-in) (0.78N.m)
C
26~16AWG
5Kg-cm(4.3 lb-in) (0.49N.m)
Wiring precautions:
Place the wires into the wiring hole and tighten the wirings with a flathead screwdriver, note that it is
best to leave 5mm spacing at the wiring end. Note [using wrings without terminal blocks and place
the wires neatly into the wiring hole] only applies to specific positions (terminals B, C in the figure
above).
Terminal Description of Function Factory setting (NPN mode)
E24V
Common terminal for digital
control signals (Source)
E24V±5% 100mA Factory setting E24V-COM short circuit
COM
Common terminal for digital
control signals (Sink)
Common terminal for multi-function input
MI1 Multi-function input terminal None (factory default), RUN/STOP, EF1. RESET*
MI2 Multi-function input terminal None (factory default), RUN/STOP, EF1. RESET*
RA1
Multi-function output contact 1
(Relay normally open a)
RB1
Multi-function output contact 1
(Relay normally closed b)
RA2
Multi-function output contact 2
(Relay normally open a)
RB2
Multi-function output contact 2
(Relay normally close b)
RC1
Multi-function output contact 1
common terminal (Relay 1)
RC2
Multi-function output contact 2
common terminal (Relay 2)
Resistive load
5A(N.O.)/3A(N.C.) 250VAC;
5A(N.O.)/3A(N.C.) 30VDC
Inductive load (COS 0.4)
2.0A(N.O.)/1.2A(N.C.) 250VAC;
2.0A(N.O.)/1.2A(N.C.) 30VDC
Outputs various monitoring signals, such as in operation
(Running), in preparation (PLL OK), error display, warning
display, and standby ready
Factory default: none
P6RS-485 port*2