Chapter 5 Troubleshooting
Operating Manual for Communicating Area Sensor
5-2
◎
Factory default setting (automatic upload)
Model
Firmware
Version
Default setting
AS-BXXXX-CX
V1.03.10
Activate automatic
upload after
powering on
Data format: first shading beam, last shading
beam, total shading beams, total shading
length(cm); 4 data in total.
AS-BXXXX-CS
Data format: the beam state in shading/non-
shading, data length=((beam numbers in model
-1)/8+1)
◎
Cancel automatic upload
Take off the connection of Transmitter model, power on receiver model individually and get the stop mode. Write 0
into 008BH can cancel Activate upload function. It works when power on Transmitter and Receiver models
simultaneously.
◎
V1.03.10 software version update
1. Rapid Light Beams Enable, 4modes for ALL ON/NOW/IN/OUT
Rapid Light
beams enable
0098H
W
Enable/disable light beams in
measurement rapidly
0: Enable all beams
1: Enable no-shading beams
2: Enable the interval beams between
start beam(0099H) and end
beam(009AH), include start beam and
end beam.
3: Enable the out of interval beams
between start beam(0099H) and end
beam(009AH), not include start beam and
end beam.
Note:
1. make sure all beams on the enable
status before setting
2. before execute 2,3, should execute
start beam and end beam.
0099H
R/W
Set start beam in rapid light
beams enable
1 ~ 128
009AH
R/W
Set endbeam in rapid light
beams enable
1 ~ 128
