13
prepared and a description of each individual phase (grind-
ing, brewing coffee) appears on the display.
Please note:
“Cancel” or Stop”: press to stop preparation completely and go
back to the homepage.
7. When delivery has ended, press “Save” to save the new set-
tings, or “Cancel” to retain the previous parameters.
8. Press “X” to go back to the homepage.
The appliance is ready to be used again.
Please note:
If you save the new settings, they are memorised ONLY in the
selected profile.
SAFETY WARNING:
After making a pot of coffee, leave the ap-
pliance to cool for 5 minutes before making
another beverage. Risk of overheating!
8.9 Cleaning the coffee pot
After each use, you should clean the coffee pot (D8) with hot
water and mild washing up liquid.
Rinse thoroughly with hot water to eliminate all detergent
residues.
9. MAKING MILK BEVERAGES
U
9.1 Preparing the milk carafes (E and F)
Please note:
To avoid milk with poor froth or large bubbles, always clean the
milk carafes as described in sections “9.6 Cleaning the milk ca-
rafe after use” and “15.9 Cleaning the milk carafes (E) and (F)”.
9.2 Which milk to use?
The quality of the froth will vary depending on:
• the temperature of the milk or plant-based beverage
(for best results, always use milk or plant-based bever-
ages at refrigerator temperature (-5°C);
• type of milk or plant-based beverage;
• brand used;
• ingredients and nutritional value.
Cow’s milk
Whole
(fat content >3.5%)
✓
✕
Partially skimmed
(fat content between
1.5 and 1.8%)
✕
Skimmed
(fat content < 0.5%)
✓
→
Plant-based beverages
Soy
✓
✓
Almond
✓
✓
Oat
✓
✓
9.3 Filling and attaching the milk carafes
1. Lift the lid (E1) or (F1) (fig. 18);
18
19
2. Fill the milk carafe (E2) or (F2) with a sufficient quantity
of milk, not exceeding the MAX level marked on the carafe
(fig. 19);
3. Make sure the milk intake tube (E6) or (F6) is correctly in-
serted on the bottom of the milk carafe lid (fig. 20);
20
21
4. Put the lid back on the milk carafe;
5. Attach the carafe to the connector (A8) and push as far as it
will go (fig. 21). The machine emits a beep (if the function
is enabled);
6. Place a sufficiently large cup under the coffee spouts (A7)
and milk spout (E5) or (F5). Only the milk spout (E5) can be
lengthened by adjusting the extension;
7. Select the beverage you want to make as described in the
following paragraphs.
Please note:
If “Energy Saving” mode is enabled (see section “6.9 General”),
you may have to wait a few seconds before the appliance makes
the beverage.
