9
5. Customise as you wish, then press “Save” to confirm.
6. Press “
<
” to save the new selection and go back to the
homepage (C).
6.8 Set auto-off
Auto-off can be set so that the appliance goes off after 15 or 30
minutes, or 1 or 3 hours of inactivity.
To programme auto-off, proceed as follows:
1. Press the settings menu (C3);
2. Scroll through the pages until “Set auto-off” is displayed;
3. Select the desired time interval (15 or 30 minutes, or 1 or
3 hours).
4. Press “X” to save the new selection and go back to the
homepage (C).
6.9 General
1. Press the settings menu (C3);
2. Scroll through the pages until “General” is displayed;
Here you can enable or disable the following functions with a
simple touch:
- “Beep sound”: when enabled, the appliance beeps when-
ever an operation is performed.
- “Energy saving”: use this function to enable or disable en-
ergy saving. When enabled, the function reduces energy
consumption in compliance with European regulations.
is displayed on the homepage to show it is active.
3. Press “X” to save the new selection and go back to the
homepage (C).
6.10 Water filter
For instructions on the filter (D4), see section “18. Water soften-
er filter””.
6.11 Water hardness
For instructions on setting water hardness, see section “17. Set-
ting water hardness”.
6.12 Default values
This resets all menu settings and user customisation back to
the default values (with the exception of the language, which
remains as set, and the statistics).
Proceed as follows:
1. Press the settings menu (C3);
2. Scroll through the pages until “Default values” is displayed;
3. Press “Next”:
4. Select whether you want to reset the entire appliance or a
single profile, then press “Next”;
5. Follow the instructions, then confirm the reset by pressing
“OK”. The machine displays the homepage (C) again.
Please note:
When the appliance (not the individual profile) has been reset
to the default values, the machine proposes the introductory
tutorial again.
6.13 Drain water
To avoid the water in the circuit freezing if the appliance is to be
left idle for a long period of time, or before taking it to customer
services, we recommend emptying the water circuit.
Proceed as follows:
1. Press the settings menu (C3);
2. Scroll through the pages until “Drain water” is displayed;
3. Press “OK” to start the guided procedure;
4. Extract, empty and replace the grounds container (A10)
and drip tray (A15) (fig. 10), then press “Next”;
10
5. Insert the spout (D6) on the connector (A8) (fig. 5);
6. Position a 100 ml container under the spouts (fig. 6). Press
“Next”;
7. The appliance performs a rinse cycle with hot water from the
spouts;
8. At the end of rinsing, extract the water tank (A22) (fig. 11)
and empty;
9. If present, remove the water softener filter (D4) from the
water tank and press “Next”;
11
10. Put the empty water tank back in the appliance and press
“Next”;
11. Wait for the appliance to empty the circuit; (Important:
hot water from the spouts!). As the water circuit empties,
the appliance could become noisier. This is part of normal
operation.
12. When the circuit is empty, extract and empty the drip tray,
put back in the appliance and press “Next”;
13. Press “OK”. The appliance goes off (standby).
