2
1.
INTRODUCTION ........................................................................................... 3
2.
MAIN FEATURES ......................................................................................... 3
3.
TECHNICAL SPECIFICATIONS ................................................................... 3
4.
CONNECTION AND SET UP OF THE CONTROL UNIT.............................. 4
4.1
GENERAL DIAGRAM OF SETTINGS AND CONNECTIONS .................................. 5
4.2
SIMPLIFIED LEARNING PROCEDURE (also see pages 8-10) .............................. 6
4.3
PROFESSIONAL LEARNING PROCEDURE (see also pages 8-10)...................... 7
5.
CONTROL UNIT OPERATING L OGIC (ANALYTIC EXAM) ........................ 8
5.1
PROGRAMMING AND CANCELLATION OF THE REMOTE CONTROLS ............. 8
5.2
OPERATION OF THE SAFETY DEVICES ............................................................... 8
5.3
MOTOR SPEED - TRIMMER “FOR” ....................................................................... 9
5.4
DELAY BETWEEN MOTORS - TRIMMER “DEL” .................................................. 9
5.5
“OPENING AND CLOSING” OPERATING MODE .................................................. 9
5.6
“PEDESTRIAN OPENING” FUNCTION ................................................................. 11
5.7
“OBSTACLE SENSITIVITY” DETECTION - TRIMMER “OBS”............................. 11
5.8
FLASHING LIGHT .................................................................................................. 11
5.9
GATE OPEN WARNI NG LIGHT............................................................................. 11
5.10
SLOW-DOWN ......................................................................................................... 11
5.11
ELECTRIC LOCK ................................................................................................... 11
5.12
COURTESY LIGHT................................................................................................. 12
5.13
BUFFER BATTERY – SOLAR PANEL MANAG EMENT ....................................... 12
5.14
LOGICAL STOP (STP INPUT)................................................................................ 12
5.15
CONTROL UNIT MEMORY FAUL T........................................................................ 12
6.
SIGNALLING LED....................................................................................... 12
7.
PROGRAMMING THROUGH GTSYSTEM ................................................. 13
8.
TROUBLESHOOTING ................................................................................ 14
SAFETY WARNINGS FOR INSTALLATION AND USE ................................................... 15
