8
5. CONTROL UNIT OPERATING LOGIC (ANALYTIC EXAM)
5.1
PROGRAMMING AND CANCELLATION OF THE REMOTE CONTROLS
With the receiver built into the control box,
BAME
rolling code remote Joy and Style can be learned.
5.1.1
Programming
Power the control panel and with the
automation stopped (green LED GC turned on):
• Press the “P2/RAD” pushbutton: the red LED lights up to indicate that the programming is activated.
• Make a transmission by pressing one of the pushbuttons on the transmitter
• The code is memorised. During code insertion, the red LED flashes slowly. At t he end, the red LED returns
to a fixed light to indicate that a new remote control can be inserted.
• Memorise all the transmitters by carrying out a transmission with a chosen channel.
• At the end of the operation press the “P2/RAD” pushbutton again to exit the procedure. The red LED
switches off.
ATTENTION: The exit from the procedure occurs automatically 10 seconds after the last transmission.
5.1.2
Total cancellation of the codes
• Press and hold down the “P2/RAD” pushbutton for 3 seconds; the red LED starts flashing quickly.
• Press the “P2/RAD” pushbutton again (within 6 seconds) to confirm the cancellation. The confirmation is
signalled when the red LED starts flashing more rapidly.
5.1.3
Enabling new remote “Rolling Code” transmitters (RPA)
To enable a new transmitter without intervening on t he receiver, a transmitter already enabled for the
authorisation must be used (MPSTP2E, MPSTL2E, MPSTL4E, MT2E, MT4E, TRQ2 or TRQ4).
•
With this authorised transmitter, press and release the RPA learning pushbutton (also see the instructions of
the TX used).
•
Carry out this operation 5-6 metres from the receiver (the LED signals the activation).
•
Transmit by pressing one of the channel pushbuttons of the new transmitter to be enabled.
•
Enable all the new transmitters by pressing a pushbutton on each one of them.
•
The exit from the procedure occurs automatically 10 seconds after the last transmission.
•
Check the effective programming of the transmitters by carrying out an opening manoeuvre with each of
them.
5.1.4
Choosing the transmitter pushbutton
To select the radio channel that will activate the manoeuvre cycle set DIP 1 and 2 as follows:
DIP- SWITCH 1
DIP- SWITCH 2
Pushbutton Active
OFF
OFF
Pushbutton 1
OFF
ON
Pushbutton 2
ON
OFF
Pushbutton 3
ON
ON
Pushbutton 4
5.2
OPERATION OF THE SAFETY DEVICES
5.2.1
Photocell (PHO input)
When triggered, the photocell provokes:
- in closing phase, an inversion of the motion, either immediate or when cleared, according to the programming,
- in opening phase it has no effect,
- when the access is closed it has no effect on the opening commands if set for immediate inversion,
otherwise it delays the opening until it is cleared,
- if the access is open it inhibits the closing commands.
The control unit has a function of rapid access closing after the triggering of the photocell (see paragraph 5.3.4).
5.2.2
Safety in Opening (EDG/PED input)
Safety devices can be connected (self-testing or not) to the “EDG/PED” input on the control unit (e.g. fixed wire
ribs, pneumatically-operated ribs, etc.).
The safety acts as follows:
- in
closing
phase
it has no effect
- in opening phase it provokes an inversion of direction for 2 seconds,
- when the gate is closed the opening commands are inhibited,
