Item Control/Feature
Icon Description
3
MGMT port (Slot 3/Port
1)
—
Ethernet/iSCSI port that is typically used for storage system
management and access to the BMC
NOTE: To use the MGMT port as an iSCSI port for
replication to another Storage Center, a Flex Port license
and replication license are required. To use the MGMT port
as a front-end connection to host servers, a Flex Port
license is required.
4
REPL port (Slot 3/Port 2) —
Ethernet/iSCSI port that is typically used for replication to
another Storage Center
NOTE: To use the RELP port as a front-end connection to
host servers, a Flex Port license is required.
5
SAS activity indicators
—
There are four SAS PHYs per SAS port.
•
Off
: SAS PHY is not connected
•
Steady green
: SAS PHY is connected, but not active
•
Blinking green
: SAS PHY is not connected nor active
6
Storage controller status
On
: Storage controller completed POST
7
Recessed power off
button
Not currently used
8
Storage controller fault
•
Off
: No faults
•
Steady amber
: Firmware has detected an error
•
Blinking amber
:Storage controller is performing POST
9
Recessed reset button
Not currently used
10
Identification LED
•
Off
: Identification disabled
•
Blinking blue (for 15 sec.)
: Identification is enabled
•
Blinking blue (continuously)
: Storage controller shut down
to the Advanced Configuration and Power Interface (ACPI)
S5 state
11
USB port
One USB 3.0 connector
12
Diagnostic LEDs (8)
—
•
Green LEDs 0–3
: Low byte hex POST code
•
Green LEDs 4–7
: High byte hex POST code
13
Serial port (3.5 mm mini
jack)
Not for customer use
14
Two options:
• Four iSCSI ports (Slot
1/Port 1, Slot 1/Port
2, Slot 1/Port 3, and
Slot 1/Port 4) with
two LEDs per port
• Two iSCSI ports (Slot
1/Port 1 and Slot 1/
Port 2) with two
LEDs per port
—
•
Off
: No power
•
Steady Amber
: Link
•
Blinking Green
: Activity
14
About the SCv2080 Storage System
