Table 4. Back panel indicator, button, or Connector description
Item
Indicator, Button, or
Connector
Icon
Description
1
PCIe expansion card
slots (3) (processor 1)
You can connect up to two PCI Express expansion
cards and one PERC card.
2
Ethernet connectors
Two integrated 10/100/1000 Mbps NIC
connectors.
3
System identification
connector
It connects the optional system status indicator
assembly through the optional cable management
arm.
4
System identification
button
The identification buttons on the front and back
panels can be used to locate a particular system
within a rack. When one of these buttons is
pressed, the LCD panel on the front and the
system status indicator on the back flash until one
of the buttons is pressed again.
Press to toggle the system ID on and off.
If the system stops responding during POST, press
and hold the system ID button for more than five
seconds to enter the BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup),
press and hold for more than 15 seconds.
5
iDRAC Enterprise port
Dedicated management port.
NOTE: The port is available for use only if the
iDRAC Enterprise license is installed on your
system.
6
Power supply (PSU1)
AC
495 W, 750 W, 1100 W, or
1600 W
or
DC
1100 W
7
USB port(6)
You can connect USB devices to the system. Four
ports are USB 2.0-compliant and two ports are
USB 3.0-compliant.
8
Video connector
You can connect a VGA display to the system.
9
Serial connector
You can connect a serial device to the system.
10
Power supply (PSU2)
AC
495 W, 750 W, 1100 W, or
1600 W
or
20
