182
Glossary
system board
— As the main circuit board, the system board usually contains most of
your system’s integral components, such as the processor(s), RAM, controllers for
peripherals, and various ROM chips.
system configuration information
— Data stored in memory that tells a system what
hardware is installed and how the system should be configured for operation.
system memory
— See
RAM
.
System Setup program
— A BIOS-based program that allows you to configure your
system’s hardware and customize the system’s operation by setting features such as
password protection. Because the System Setup program is stored in NVRAM, any
settings remain in effect until you change them again.
TCP/IP
— Transmission Control Protocol/Internet Protocol.
termination
— Some devices (such as the last device at each end of a SCSI cable)
must be terminated to prevent reflections and spurious signals in the cable. When
such devices are connected in a series, you may need to enable or disable the
termination on these devices by changing jumper or switch settings on the devices or
by changing settings in the configuration software for the devices.
TOE
— TCP/IP offload engine.
U-DIMM
— An unregistered (unbuffered) DDR3 memory module.
uplink port
— A port on a network hub or switch used to connect to other hubs or
switches without requiring a crossover cable.
UPS
— Uninterruptible power supply. A battery-powered unit that automatically
supplies power to your system in the event of an electrical failure.
USB
— Universal Serial Bus. A USB connector provides a single connection point for
multiple USB-compliant devices, such as mice and keyboards. USB devices can be
connected and disconnected while the system is running.
USB memory key
— See
memory key
.
utility
— A program used to manage system resources—memory, disk drives, or
printers, for example.
V
— Volt(s).
VAC
— Volt(s) alternating current.
VDC
— Volt(s) direct current.
VGA
— Video graphics array. VGA and SVGA are video standards for video adapters
with greater resolution and color display capabilities than previous standards.
video adapter
— The logical circuitry that provides (in combination with the monitor)
your system’s video capabilities. A video adapter may be integrated into the system
board or may be an expansion card that plugs into an expansion slot.
book.book Page 182 Tuesday, March 31, 2009 5:26 PM
Summary of Contents for PowerEdge R410
