Next steps
1.
2. Follow the procedure listed in
After working inside your system
.
Intrusion switch module
This is a service technician replaceable part only.
Removing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in
Before working inside your system
3.
.
Steps
1. Disconnect and remove the intrusion switch cable from the connector on the system board.
Observe the routing of the cable as you remove it from the system.
2. Using the Phillips #1 screwdriver, remove the screw securing the intrusion switch module.
3. Lift the intrusion switch module out of the system.
Figure 25. Removing the intrusion switch module
Next steps
.
Installing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in
Before working inside your system
3.
.
Installing and removing system components
33
Summary of Contents for EMC XC Core XC450
Page 1: ...Dell EMC XC Core XC450 Installation and Service Manual September 2021 ...
Page 13: ...Figure 11 Memory information Dell EMC XC Core XC450 system overview 13 ...
Page 14: ...Figure 12 Service information electrical overview 14 Dell EMC XC Core XC450 system overview ...
Page 15: ...Figure 13 Service information mechanical overview Dell EMC XC Core XC450 system overview 15 ...
