Dell EMC XC Core XC450, Installation And Service Manual

Page: 98 / 109

iDRAC Quick Sync 2 indicator codes
iDRAC Quick Sync 2 module (optional) is located on the left control panel of the system.
Table 21. iDRAC Quick Sync 2 indicators and descriptions
iDRAC Quick Sync 2 indicator
code
Condition Corrective action
Off (default state) Indicates that the iDRAC Quick Sync 2
feature is powered off. Press the iDRAC
Quick Sync 2 button to power on the
iDRAC Quick Sync 2 feature. If the LED fails to power on, reseat the left
control panel flex cable and check. If the problem
persists, see the
Getting help section.
Solid white Indicates that iDRAC Quick Sync 2 is
ready to communicate. Press the iDRAC
Quick Sync 2 button to power off. If the LED fails to power off, restart the system.
If the problem persists, see the
Getting help
section.
Blinks white rapidly Indicates data transfer activity.
If the indicator continues to blink indefinitely, see
the
Getting help section.
Blinks white slowly Indicates that firmware update is in
progress.
If the indicator continues to blink indefinitely, see
the
Getting help section.
Blinks white five times rapidly
and then powers off Indicates that the iDRAC Quick Sync 2
feature is disabled. Check if iDRAC Quick Sync 2 feature is
configured to be disabled by iDRAC. If
the problem persists, see the
Getting help
section. www.dell.com/poweredgemanuals or Dell
OpenManage Server Administrator User’s Guide
at https://www.dell.com/openmanagemanuals .
Solid amber Indicates that the system is in fail-safe
mode. Restart the system. If the problem persists, see
the
Getting help section.
Blinking amber Indicates that the iDRAC Quick Sync 2
hardware is not responding properly. Restart the system. If the problem persists, see
the
Getting help section.
iDRAC Direct LED indicator codes
The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC
subsystem.
You can configure iDRAC Direct by using a USB to micro USB (type AB) cable, which you can connect to your laptop or
tablet. Cable length should not exceed 3 feet (0.91 meters). Performance could be affected by cable quality. The following table
describes iDRAC Direct activity when the iDRAC Direct port is active:
Table 22. iDRAC Direct LED indicator codes
iDRAC Direct LED
indicator code
Condition
Solid green for two
seconds Indicates that the laptop or tablet is connected.
Blinking green (on for
two seconds and off for
two seconds) Indicates that the laptop or tablet connected is recognized.
98 System diagnostics and indicator codes