Figure 42. Cabling Diagram—3.5 Inch (x12) SAS/SATA Backplane
1. cable retention bracket
2. system board
3. integrated storage controller card
4. SAS connector on the system board
5. SAS backplane
Installing The Hard-Drive Backplane
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1.
Use the hooks at the base of the chassis as guides to align the hard-drive backplane.
2.
Slide down the hard-drive backplane until the release tabs snap into place.
3.
Connect the SAS/SATA/SSD data, signal, and power cable(s) to the backplane.
4.
Replace the cooling-fan assembly.
5.
Replace the cooling shroud.
6.
Install the hard drives in their original locations.
7.
Close the system.
8.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
9.
If applicable, install the front bezel.
82
Summary of Contents for DX6112-SN
