Dell DX6112-SN, Owner'S Manual

Page: 121 / 125

Error Code Message Information
Action Close the chassis and verify hardware inventory. Check system logs.
SEL0006
Message All event logging is disabled.
Details This message is displayed when all event logging has been disabled
by the user.
Action If unintended, re-enable logging.
SEL0008
Message Log is full.
Details When the event log is full, additional events are not written to the log.
Older events may be overwritten and lost. This message may also
appear if the user disabled event logging.
Action Backup and clear log.
SEL0012
Message Could not create or initialize the system event log.
Details If the system event log fails to initialize, platform status and failure
events are not captured. Some management software do not report
platform exceptions.
Action Reboot the management controller or iDRAC. Cycle system input
power. If problem persists call support.
SEL1204
Message An unknown system hardware failure detected.
Details If the system event log failed to initialize, platform status and failure
events are not captured. Some management software do not report
platform exceptions.
Action Re-configure system to the minimum supported configuration. If
issues persists, contact support.
TMP0118
Message The system inlet temperature is less than the lower warning
threshold.
Details Ambient air temperature is too cool.
Action Check the system operating environment.
TMP0119
Message The system inlet temperature is less than the lower critical threshold.
Details Ambient air temperature is too cool.
Action Check the system operating environment.
121