○
Torx T10
●
Flashlight
●
Needle nose pliers
●
Diagonal wire cutters (for cutting tie wraps)
●
2 GB or greater USB flash memory drive
●
Tie wraps (4 in. and 8 in.)
●
(recommended) Roll of 5/8 inch Velcro cable tie material (3M Scotchmate SJ-3401 or similar)
Safety information
CAUTION:
●
If the system is used in a manner not specified by the manufacturer, the protection provided by the
equipment may be impaired.
●
The RJ45 sockets on the motherboard, PCI cards, or I/O modules are for Ethernet connection only and must
not be connected to a telecommunications network.
Review this list of important safety recommendations.
●
All plug-in modules and blank plates are part of the fire enclosure and must be removed only when a replacement can be
added immediately. The system must not be run without all parts in place.
●
A DD9500 system must be operated only from a power supply input voltage range of 200–240 VAC and 50–60 Hz. ES30
shelves use 100-240 VAC and 50–60 Hz. DS60 shelves use 200–240 VAC and 50–60 Hz.
●
Each component is intended to operate with all working power supplies installed.
●
Provide a suitable power source with electrical overload protection.
●
A safe electrical earth connection must be provided to each power cord. Check the grounding of the power sources before
applying power.
●
The plug on each power supply cord is used as the main device to disconnect power from the system. Ensure that the
socket outlets are located near the equipment and are easily accessible.
●
Permanently unplug the unit if you think it is damaged in any way and before moving the system. A DD9500 system includes
four power supplies. To completely remove system power, you must disconnect all four power supplies.
●
The power connections must always be disconnected prior to removal or replacement of a power supply module from any of
the components in the system.
●
A faulty power supply module must be replaced within 24 hours.
●
Do not lift system components by yourself. A DD9500 system weighs up to 117 lbs (53.2 kg), an ES30 expansion shelf
weighs up to 68 lbs (30.8 kg), and a DS60 shelf weighs up to 225 lbs (90.7 kg).
CAUTION:
Data Domain systems are heavy. Use at least two people or a mechanical lift to move any system.
●
Do not lift an expansion shelf by the handles on any modules. The handles are not designed to support the weight of the
populated shelf.
●
To comply with applicable safety, emission, and thermal requirements, covers must not be removed and all bays must be
fitted with plug-in modules.
●
Once removed from the shipping box, it is ok to lift the DD9500 system or the chassis with the four handles to place in a
rack. You will need to remove the handles from the sides before sliding the system in the rack. The four handles should be
saved for later use.
Introduction and Preparation
9
