B-10
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug fastethernet
debug fastethernet
Use the
debug fastethernet
privileged EXEC command to enable debugging of the Ethernet
management port. Use the
no
form of this command to disable debugging.
debug fastethernet
{
af
|
events
|
packets
}
no debug fastethernet
{
af
|
events
|
packets
}
Syntax Description
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
The
undebug fastethernet
{
af
|
events
|
packets
} command is the same as the
no debug fastethernet
{
af
|
events
|
packets
} command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the
session
switch-number
privileged EXEC command. Then enter the
debug
command at the command-line
prompt of the stack member. You also can use the
remote command
stack-member-number
LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
af
Display Ethernet management port software-address-filter debug messages.
events
Display Ethernet management port event debug messages.
packets
Display Ethernet management port packet debug messages.
Release
Modification
12.2(40)EX1
This command was introduced.
Command
Description
show debugging
Displays information about the types of debugging that are enabled.
show controllers
ethernet-controller
fastethernet
Displays information about the Ethernet management port.
