Dell Brocade 815, Troubleshooting Manual

Page: 159 / 172

Brocade Adapters Troubleshooting Guide 135
53-1002145-01
HCM and Installer Message Reference
B
The WWN or MAC
address already exists in
the All WWNs/MACs
table. Edit the existing
record(s). Record(s) with
the same WWN address
are highlighted. Occurs when user enters a WWN or MAC
address which is already present the
WWN/MAC field in the Devine Names dialog
box. Check the same WWN or MAC
address is available in the
WWNs/MAC view of the Configure
Names dialog box. Enter a different
WWN or MAC address.
There are VLANs
associated with the port
you have selected to be
added as a member of
the team. If you add the
port, all associated
VLANS will be removed.
Are you sure you want to
add this port to the team
and remove all
associated VLANs? Occurs when the user creates a team with a
port for which a VLAN is already configured. Remove the VLAN configured for the
port, and then try creating a team
with that port.
This action resets all
listed counters. Do you
want to continue? Occurs when the user selects Reset on a
Statistics dialog box. Select Yes to reset all the counter
values in the dialog box.
Unexpected Error. Test(s)
will be stopped. Occurs when the user tries to execute the
diagnostics test when the agent is stopped. Start the agent, and then execute
the diagnostics test.
Unexpected Error. eth
Loopback Test will be
stopped. Please contact
the technical support Occurs when the user executes the loopback
test for a port and connection is lost. Verify the connection, and then
proceed with loopback test.
Unable to find the host.
Please provide another
host. Occurs when an invalid host name or IP
address is given in Host Name field in the
Setup for Discovery dialog box. Enter a valid host name or IP
address in the Host Name field.
Unable to extract the
driver file {0}. Occurs when the driver cannot be extracted.
Unable to find the host.
Please provide another
host. Occurs when link local ipv6 address (such as
fe80:216:cbff:fea9:c3b5%en0 or
fe80:216:cbff:fea9:c3b5%3) is provided in the
Setup for Discovery dialog box. Provide the IPv6 address without
using the scope-id and the delimiter
(%). Just use
fe80:216:cbff:fea9:c3b5.
Unable to retrieve the
driver update status. Occurs when the driver update status cannot
be retrieved. Information message.
Update is not started
beyond the timeout
value. Closing the driver
update operation. Occurs when the driver update did not start the
timeout value was reached. Information message.
Uploading of the driver
file is failed. Occurs when driver file upload failed to Agent
host. Information message.
Uploading of the driver
file is failed. Reason -
Maintenance mode is
not enabled or could not
be determined. ESX systems must be in maintenance mode to
update drivers. Place system in maintenance mode
and reinstall driver(s).
TABLE 14 Host Connectivity Manager messages (continued)
Message Cause Corrective Action or Notes