272
Configuring Switch Information
www
.dell.com | support.dell.com
Defining GARP Timers Using CLI Commands
This table summarizes the equivalent CLI commands for defining GARP timers as displayed in the
GARP Timers
page.
The following is an example of the CLI commands:
Table 7-73.
GARP Timer CLI Commands
CLI Command
Description
garp timer {join | leave | leaveall}
timer_value
Adjusts the GARP application join, leave,
and leaveall GARP timer values.
console(config)#
interface ethernet
1/e1
console(config-if)#
garp timer leave
900
console(config-if)#
end
console#
show gvrp configuration ethernet
1/e11
GVRP Feature is currently Disabled on the device.
Maximum VLANs: 223
Port(s)
GVRP-
Registration Dynamic VLAN
Timers
(milliseconds)
Status
Creation
Join
Leave
Leave All
---------
-------
--------
------------
------------
-------
------
1/e11
Disabled
Normal
Enabled
200
900
10000
Summary of Contents for 48 Port Gigabit Ethernet Switch
