Dell 3010cn - Color Laser Printer, Service Manual

Page: 624 / 638

8 – 8
Chapter 8 Printer Specifications
4.7 Warm-up Time
When nominal voltage (100V, 115V, 220V) is applied, the printer will proceed to standby mode from
POWER-ON within 37 seconds.
Reference: Measured at 22°C, 55% RH, nominal voltage.
4.8 FPOT (First Print Output Time)
FPOT time of the printer is shown in the table below.
The time required for the first sheet of paper to be delivered after the PRINT indication is given is
calculated on the following conditions (rounded to one decimal place).
• IOT performance that the controller does not have IOT wait.
• The printer is in the standby mode. (ROS MOTOR OFF, FUSER READY)
• Paper is A4 or Letter SEF
• Except when process control is operating*1
*1:Process controller operation is process controls such as TC control, electric potential control,
cleaning cycle, registration control, and so on. Sometimes, the engine stops feeding papers for
a certain period of time while continuous printing for these operations.
4.9 Continuous Printing Speed
The continuous printing speed is shown in the below.
OS PDL
measurment
chart
Paper SIZE Paper
Paper is
fed to i
Color
mode
FPOT
XP Like a GDI J9E A4/Letter SEF Normal paper MPF F/C
≤
25
XP Like a GDI J9E A4/Letter SEF Normal paper MPF B/W
≤
16
OS PDL
measur-
ment chart
Paper SIZE Paper
Paper is
fed to ;
Color
mode duplex/
siplex
FPOT
XP Like a GDI J11E A4/Letter SEF Normal paper MPF F/C siplex
≤
158
XP Like a GDI J11E A4/Letter SEF Normal paper MPF B/W siplex
≤
45