Steps
1
Using a Phillips #2 screwdriver, remove the screws that secure the LAN on Motherboard (LOM) riser card to the system board.
2
Push apart the two blue plastic clips securing the LOM riser card to release the riser.
3
Hold the LOM riser card by the edges on either side, and lift to remove it from the connector on the system board.
4
Slide the LOM riser card towards the front of the system until the Ethernet connectors or the SFP+ are clear of the slot in the back
panel.
Figure 59. Removing the LOM riser card
5
Remove the LOM bracket.
a Using the Phillips #2 screwdriver, remove the screw that secures the bracket to the chassis.
b Slide the bracket out of the slot on the chassis.
Figure 60. Removing the LOM bracket
6
If the LOM riser is not being replaced immediately, install the LOM filler bracket.
a Insert and slide the filler into the slot on the chassis.
b Using the Phillips #2 screwdriver, secure the filler bracket to the chassis with a screw.
Installing and removing system components
99
