NOTE:
For low profile riser right, tighten the captive screw to secure the riser to the system
board.
Figure 52. Installing the low profile right riser
Next steps
1
If required, re-connect the cables to the expansion card.
2
Install the air shroud. For more information, see
.
3
Follow the procedure listed in
After working inside your system
.
4
Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the expansion card riser
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
Remove the air shroud. For more information, see
.
4
If applicable, disconnect the cables from the expansion card.
Steps
1
Pull and lift up the expansion card retention latch lock to open.
2
Hold the expansion card by its edges, and pull the card until the card edge connector disengages from the expansion card connector
on the riser.
92
Installing and removing system components
