Installation Manual
Festoon Systems for I-Beams
Program 0314
MAL0300-0001-EN
www.conductix.com
translated document
page 40 of 56
WARNING!
Danger of crushing!
When moving the festoon system, there is a danger of crushing limbs between the buffer and buffer
plate, as well as between the carriage and the track carrier.
Therefore:
- When the system is moving, do not enter the traveling area of the festoon system.
CAUTION!
Trap!
There is a danger of being trapped when the cable-festoon system is moving.
Therefore:
- When the system is moving, do not enter the traveling area of the festoon system.
Personnel:
The system may only be operated by trained personnel!
7.2
Functioning
A festoon system consists of end clamp and cable trolley. The last cable trolley is coupled via the line to the mobile consumer via
which the subsequent cable trolleys are pulled.
The dimensions of the festoon system can be found in the project-specific dimension sheet.
During operation, the system should be monitored for any changes in operating noise and irregularities.
If irregularities are identified during operation, the system must be shut down immediately. The cause of the fault is to be
determined using the fault table (see Chapter 9).
The fault table includes the causes for the disturbance as well as the recommendations for their remedy. If the cause cannot be
identified, or a repair cannot be effected using the Operator's own resources, we recommend that a customer service engineer be
called from one of our customer service points.
