Installation Manual
Festoon Systems for I-Beams
Program 0314
MAL0300-0001-EN
www.conductix.com
translated document
page 31 of 56
6.3.1
Assembling the festoon
The cable trolleys can be pushed into the front end of the track beam or mounted from below on the track beam. The trolleys must
be adjusted to the respective track beam (see Adjusting the trolleys).
6.3.2
Adjusting the trolleys
Fig. 19: Adjusting the trolleys
The side parts of the chassis are movable on the rail. They have to be adjusted to the track beam. The distance A between the two
side parts of the cable trolley should be
max. support width + 40 mm
.
The cable trolley base is to be centrally located below the track beam after adjustment. After adjustment, tighten the screws.
6.3.3
Mounting the end clamp
The end clamp is fastened to the track beam (provided by the customer) using a screw connection. Select the position of the end
clamp so that when arranging the cables, the smallest bend radius of the cables can be maintained. The installation length is to be
selected so that the cable is lying completely on the support and that the clamping is sufficient during operation.
Side part
Track beam
Rail
