Installation Manual
Festoon Systems for I-Beams
Program 0314
MAL0300-0001-EN
www.conductix.com
translated document
page 18 of 56
3.4.3
Girder joint for non-welded track beams
For non-welded girder joints, the gap between beams may be
at most 8 mm
. The cut is at a
45°
angle.
Required tools and materials:
NOTE!
Fig. 4: Girder joint for non-welded track beams
For non-welded girder joints, the horizontal and vertical deviation of the opposing sides of the joint may be
at most 2 mm
.
Transitions must be ground smooth within
about 100 mm
of the beginning of the cut. All transitions must be
beveled and
rounded
.
Required tools and materials:
NOTE!
Fig. 5: Girder joint for non-welded track beams
Edges chamfered and
rounded
Edges chamfered and
rounded
Horizontal and vertical deviation
2 mm
