13
TrioPure
TM
Sanitation System
DEL Ozone · San Luis Obispo, CA 93401 · USA · 800-676-1335 · Fax: 805-541-8459
SECTION 4
Operation
4A Initial Start-Up Procedure
CAUTION:
Depending on water temperature and turnover in
pool, it may take several days for the salt to dissolve and salin-
ity levels to be measured accurately. Do not add additional
salt to pool unless all salt is dissolved and salinity measure-
ments are consistently less than 3,000 ppm.
CAUTION:
Operating the TrioPure with pool salinity below
3,000 ppm will severely reduce cell life.
Step 1
- Before starting the TrioPure, manually add chlorine
to the water for the first week to a minimum level of 1 ppm
and ensure that all water chemistry parameters are within
the specified limits.
Check the water chemistry, water tem-
perature, and salt level (salinity) and adjust as needed – all
must be within the limits specified in
Section 5B, Monitoring &
Maintenance
, of this manual before starting the TrioPure
TM
.
Step 2 -
Turn on main pool pump before starting the TrioPure
TM
.
Note:
Ozone may cause temporary clouding of water in pool on
initial startup (first 24-48 hours) as the ozone causes organic
matter to flocculate (stick together) and minerals to precipitate
out so that they can be trapped in the pool filter. Clean filter as
needed until pool water is clear.
Step 3 -
Become familiar with the controls, indicators, and
features of the TrioPure
TM
. See
Figure 15
below (TrioPure-50
shown)
1. Chlorine Production Display
2. Chlorine Control Knob
3. Low Salt Indicator
4. High Salt Indicator
5. Ozone Production Indicators
1
2
5
10
9
8
3
4
7
6
6. Water Flow Indicator
7. Water Temp. Indicator
8. On/Off Switch
9. Fuse (right side)
10. Serial Number # (left side)
Figure 15
Summary of Contents for TrioPure 25
Page 30: ......
