proxSafe flexx
V08/09/09
ps_flexx_wi_en
13
3.3
Mount Terminal to flexx housing
The proxSafe flexx is supplied for right-hand side mounting. So the following steps show
the mounting process on the right side of the flexx housing. If you prepared your Terminal
for left-hand side mounting, use the according wholes on the left side of the housing.
1.
Guide the two terminal cables through the
hole in the back of the terminal bracket.
3.
Fix the terminal to the flexx frame with the
two enclosed screws (use a short or an
angled screw driver).
2.
Position the terminal bracket behind the flexx
frame.
After this guide the two cables from the terminal (“Master” and “Slave”) through the cable
opening at the back of the flexx housing to prepare the housing for wall mounting.
(For connection of the terminal cable later on refer to 3.11 “Connect terminal to
backplane PCB”.)
