proxSafe flexx
10
ps_flexx_wi_en
V08/09/09
3.2.1
Change door orientation
In order to change the door orientation to a locking cylinder on the left-hand side, you
have to proceed as follows:
1.
Press down the lever of the tension spring
while holding the door with the other hand.
Then slightly tilt the door until it can be taken
out completely.
3.
Now remove the two plastic studs at the
bottom and top of the left side, in which the
door pins had been inserted before, and put
them into the according wholes on the right
side of the housing (top and bottom!).
Then push the plastic cover (the one you
removed in picture 2) back into place on the
left side of the housing (only bottom hole).
2.
Carefully remove the plastic cover from the
hole for the door pin (at the bottom of the
housing on the right side).
4.
I
nsert the door pins of the front door, first
the top one and then the one at the
bottom, while keeping the tension spring
lifted. Once the pins are in place, you can
release the spring.
