proxSafe flexx
28
ps_flexx_wi_en
V08/09/09
3.11
Connect terminal to backplane PCB
In order to establish a connection between the terminal and the backplane proceed as
shown in the picture below:
Plug the two supplied cables coming from
the terminal into the backplane PCB:
Cable “Master” -> Plug “Terminal MUX”
Cable “Slave” -> Plug “Terminal PC”
3.12
Connect LEDs
In order to connect the LEDs on top of the flexx housing, proceed as shown in the picture
below:
Plug the LED cable (coming down within the
housing) from the LEDs on top of the flexx
into the connector “LEDs” on the flexx
backplane PCB.
After the LED cable has been connected to
the backplane PCB and the power has been
turned on, the three LEDs should look as
shown in the picture:
yellow:
standard operating mode;
always active, as long as power on
green:
after door has been released
for taking or returning keys
red:
alarm case
