Description
Notes
Block mode
Block running mode.
Lamp test
Activate lamp test (LEDs on display).
Ack. all alarms
Acknowledge all alarms.
Set to local start
Select local start in a power management application.
Set to remote start
Select remote start in a power management application.
Set clock to 4 am
Set the controller clock to 04h00.
Set BA parameter [1-4]
Choose the parameter set for nominal settings for busbar A.
Activate capacity overrule
See
Option G7 Extended power management
.
Deactivate capacity overrule
See
Option G7 Extended power management
.
TB close inhibit
Prevents the tie breaker from closing.
Select application [1-4]
Power management: Select the power management application from the
controller.
Update mode local
The running mode for the local controller in the power management system is
updated to the selected mode.
Update mode on all
The running mode for all controllers in the power management system is updated
to the selected mode.
Store common settings
See
Handling settings for sections
in
Option G5 Power management
.
Open TB
Open the tie breaker.
Close TB
Close the tie breaker.
Auto start/stop
ON = Start, OFF = Stop.
First priority
Forces this controller to have the first priority in a power management system.
Activate Asymmetric LS
Activate asymmetric load share.
Deactivate Asymmetric LS
Deactivate asymmetric load share.
Select three phase system
Sets the controller to work in a three-phase system.
Select split L1L3 phase system
Sets the controller to work in a two-phase system (L1-L3).
Select split L1L2 phase system
Sets the controller to work in a two-phase system (L1-L3).
Select single phase system
Sets the controller to work in a single-phase system (L1).
Inductive reference
Inductive cos phi reference.
Capacitive reference
Capacitive cos phi reference.
Act. power offset [1-3]
Activate the power reference offset.
Deact. power offset [1-3]
Deactivate the power reference offset.
Act. cos phi offset [1-3]
Activate cos phi reference offset.
Deact. cos phi offset [1-3]
Deactivate cos phi reference offset.
Reset horn
Reset the horn relay.
Reset I max. demand
Reset the peak current detected in the controller.
Reset I thermal demand
Reset the thermal current detected in the controller.
Pulse counter [1-2]
Increase the selected pulse counter.
Reset pulse counter [1-2]
Reset the selected pulse counter.
Set BB parameter [1-2]
Select the parameter set for busbar nominal settings.
Ack. mains protection alarms
Acknowledges all mains alarms including: 1270-1430, 1660, 1700, 1960, 1970,
7480-7490.
Application note 4189341276B EN
Page 40 of 50
