Decision Data IS-488, User Manual

Page: 152 / 162

Operator Messages
Error Code Cause Corrective Action
An error occurred after sign-on. The
program utility didn’t recognize the key
you pressed. Key Reset . Attempt to run a different job
type or procedure. If error occurs, consult
system operator to find out if problem
exists with the system. If the problem
does not reoccur, you have a system
programming problem or keying error.
9001 Your record table has filled up. You
cannot enter any more keystrokes.
Key Record.
Entering a new keystroke sequence:
first, remove an existing key sequence
defined under one command key by:
keying
Record and that command key,
then enter the new key sequence.
Alternatively, to erase the recorded key
sequence, key
Record , key that command
or function key, then key Del .
9002 Invalid record table format. Key Reset and proceed with the
record/play operation.
9003 While using the record or play function,
you pressed a key other than
Alt ,
Record or Shift before pressing a valid
command key.
Key Reset or valid command key.
9004 You pressed one of the command keys
while holding down
Alt during record or
play operation.
Press the command key only.
9007
You keyed either Play or Setup while
recording a key sequence. They are
invalid sequence keys.
Key a valid sequence key.
9010 A command key was pressed which
does not have a key sequence under it
during a Play operation. Key Reset or a command key which a key
sequence has been assigned.
9011
You attempted to key Setup with Shift
pressed.
Key Setup only.
D-7