HUMMER H1: STEP BY STEP
2
11
66
77
88
22
44
33
55
These photos will help
you to identify the
front and back of each
component.
Use a size 2 Phillips screwdriver to tighten the screw. Do not tighten
the screw fully: leave about 1mm between the screw head and the
front face of the gear.
Repeat Steps 5 and 6 for the other screws.
At this point in the assembly there should be 1mm gaps between the
heads of the screws (circled in red) and the front face of the gear.
Place the projection on the front of the gear holder into the hole in
the 46T gear, inserting it from the back.
Push the gear holder and gear together firmly until there are no
gaps between them.
Align the three holes in the holder with the three countersunk holes
on the gear.
Insert one of the screws into one of the countersunk holes on the
front of the gear.
Assembling
the 46T gear
and holder
Projection.
Groove either side of
the hole.
Three countersunk
holes.
Raised ridge in the
recess.
Front
Back
