HUMMER H1: STEP BY STEP
19
77
11
11
99
13
13
88
12
12
10
10
14
14
Push the O-ring down the joint until it sits in the recess that you
greased in Step 2.
Adjust the position of the pin so that it protrudes evenly from
both sides of the joint.
Use tweezers to grip the 2.5mm x 10.3mm pin.
Hold the 20T bevel gear as shown. Locate the highlighted
groove on the back of the gear.
Place the 6 × 12mm shim over the joint and push down to rest
on the O-ring.
Smear some extra grease around the shim and the joint.
Insert the 2.5 × 10.3mm pin into the hole in the joint, just above
the shim.
Align the groove on the back of the bevel gear with the position
of the pin and insert the gear into the back of the case, sliding it
over the joint and the pin.
